Description: 406 Cubic Inch Chevrolet Injected Sprint Car Motor For Sale
406 Cubic Inch Chevrolet Injected Sprint Car Motor For Sale
UPDATE: SALE PENDING - 10/27/18
Complete Racing Engine For Sale
Engine Build Sheet Information:
Crower 3.8 Inch Crankshaft – New in 1993
Carillo 6 Inch Steel Connecting Rods
Diamon #8096 Pistons – Locks – Single .074
Ferrea P 70000 Wrist Pins
Crane Camshaft – 11R000063
Crane Lifters – 11542 – 16
Childs and Albert Piston Rings – RS 442 x 4.130
Summers Brothers Steel Gear Drive
Diamond 7.925 Pushrods
Brodix – 11 Cylinder Heads
2.080 Stainless Intake Valves
1.625 Stainless Exhaust Valves
Isky 9365 Springs
Installed Height 1.950
Crane 1.6 Intake Rocker Arms
Crane 1.6 Exhaust Rocker Arms
Fel-Pro 1003 Head Gasket
Fel-Pro 2909 Rear Main Seal
National 9845 Front Crank Seal
Diamond 066132 Oil Pan Gasket
Fel Pro 1207 Intake Gasket
Clevite 5mJ038P Std. Main Bearings
Clevite CB663V Std. Rod Bearings
Spring Lash .010
This was a Doug Kalitta engine that had been freshened at Klein Racing Engines in Arizona
This engine - after being purchased and refreshed - has had only about an hour of use before the racing program disbanded.
There is one plug that has a helicoil.
In the short time with this engine I never had a problem with this plug.
The heads on the motor are Brodix -11 but were reworked at the Kalitta shop.
I have been told that he set a track record at one of the asphalt USAC tracks with this motor.
This racing engine has been sitting quite a while so it is recommended that the new owner should probably pop the pan, check and grease the bearings, etc.